Polycom EagleEye Director - Finalizing and Saving the Project; Confirming Physical Wiring

11 

Figure 17 - Editing the volume control event to use the ToLocalRoom group in place of the Amplifier channel.
ClickOKtosavetheeventandtheresultisshowninFigure18.

Figure 18 - The resulting volume control event after editing and saving the event.
NowifthevolumechangesontheHDXcodec,eitherviaanHDXIRremoteoranexplicitHDXAPIcommandforadjusting
thevolume,theToLocalRoomgroupwithinSoundStructurewilltrackthatchangeand,becauseToLocalRoomisagroup,
changeswilladjustthegroupmembers:AmplifierandEagleEye.Thiswill
automaticallymakeitlouderorquieterto
boththeaudioamplifierchannelandtotheEagle EyeDirector.
Confirming the Physical Wiring Matches the Project Wiring
Nowthattheprojectisconfiguredproperly,thenextstepistoconfirmthephysicalwiringoftheaudiototheAmplifier
andtotheEagleEyeDirector.NavigatetotheWiringpageand
expandtheoutputareaasshowninFigure19.Inthis
figuretheAmplifierisconnectedtooutputs1and2andtheEagleEyeDirectorisconnectedtooutputs3and4.