Polycom, Inc. 105
System Display
This section provides information on setting up features involving the phone’s user interface.
Capture Your Device's Current Screen
You can capture your phone or expansion module's current screen. Note that the Polycom Trio solution does
not support expansion modules.
Before you can take a screen capture, you must provide power and connect the expansion module to a
phone, and enable the phone's web server using the parameter
httpd.enabled
.
To capture a device’s current screen:
1 In the
sip-interop.cfg
template, locate the parameter
up.screenCapture.enabled
.
You can add the
sip-interop.cfg
template to the CONFIG-FILES field of the master configuration
file, or copy the parameter to an existing configuration file.
2 Set the value to 1 and save the configuration file.
3 On the device, go to Settings > Basic > Preferences > Screen Capture.
Note you must repeat step 3 each time the device restarts or reboots.
4 Locate and record the phone's IP address at Status > Platform > Phone > IP Address.
5 Set the phone to the screen you want to capture.
6 In a web browser address field, enter
https://<phoneIPaddress>/captureScreen
where
<phoneIPaddress>
is the IP address you obtained in step 5.
The web browser displays an image showing the phone's current screen. You can save the image as
a BMP or JPEG file.
Capture Your Device’s Current Screen Parameters
User the following parameters to get a screen capture of the current screen on your phone or expansion
module.
To Next Page
Loading...
Need help?
General
