LCD MENU STRUCTURE
VORTEX EF2201 Reference Manual 16 Technical Support: 800.932.2774
adjusted — you should hear changes as the parameter is changing. RS-232 control
strings are also sent via the RS-232 port so your remote control device is instanta-
neously updated as well. Press E
NTER to select and store the parameter value or press
E
SC to cancel the selected value and return to the old value. Pressing HOME has the
effect of pressing E
SC then HOME, so the selected value will be cancelled and the
menu will return to the top of the menu tree.
Parameters that toggle or select among a list of options will wrap around when you
reach the end, but parameters that adjust numeric values will not wrap around once
the maximum or minimum value is reached. While adjusting a parameter, the U
P/
D
OWN button must be held down briefly before the repeat rate increases.
S
YSTEM
M
ENU
The SYSTEM menu contains POWER ON PRESET, ACKNOWLEDGEMENT MODE, ERROR
M
ESSAGES, FRONT PANEL LOCK, FRONT PANEL PASSWORD, DEVICE ID, BAUD
R
ATE, FLOW CONTROL, METER, NON-VOLATILE MEMORY LOCK, NON-VOLATILE
M
EMORY PASSWORD, SCREEN SAVER, SOFTWARE VERSION, and REBOOT EF2201
configurations.
Power On Preset. Choose the EF2201 Preset for power up.
Acknowledgement Mode. This command controls whether or not status mes-
sages are sent.
Error Messages. Turns error messages On or Off.
Front Panel Lock. Locks or unlocks the front panel. When the front panel is
locked, you can see the parameters but you cannot change them.
The default passcode is aspi (case is important).
Front Panel Passcode. Once the device has been unlocked, the passcode may
be changed. At the F
RONT PANEL PASSCODE menu, press ENTER and then enter a
passcode and press E
NTER until you reach the end of the screen.
Device ID. Selects the Device ID of the unit.
Baud Rate. Selects baud rate of the RS-232.
Flow Control. Selects flow control between Hardware, None, or Auto.
Meter. Selects which signal is displayed on the front panel LED meter.
Non-Volatile Memory Lock. Controls the non-volatile lock feature. When
the non-volatile memory is locked, you can query the settings but will get an error if
you try to change them.
Non-Volatile Memory Password. This feature sets or queries the non-vola-
tile lock password. This password is used in conjunction with N
ON-VOLATILE MEM-
ORY LOCK. The default password is aspi (case is important).
Screen Saver. Enables or disables the screen saver on the LCD panel. You can
also set the idle time.
Last Restored Preset. Displays the last restored Preset.
Software Version. Queries the software version.
Figure 8. EF2201
System submenu
System
Power On Preset
Error Messages
Acknowledgeme
nt Mode
Front Panel
Password
Device ID
Front Panel Lock
Non-Volatile
Memory Lcok
Non-Volatile Mem
Password
Meter
Last Restored
Preset
Reboot
Screen Saver
Baud Rate
Flow Control
Software Version
To Next Page
Loading...
