9
What is a Mesh Network
Approach Sensor
SmartStat works using a mesh network, meaning SmartStats have the ability
to send & receive signals via other thermostats on the network. This signal is relayed
from one thermostat to another until it reaches its destination. This communication
method extends the communication range whilst oering increased network stability
when compared with standard RF thermostats.
The Mesh symbol is shown when the device is communicating with the Hub, if the
mesh symbol disappears this indicates connection to the SmartHub has been lost.
The SmartStat uses proximity to detect when you are about to use the touch
keys. As you approach the thermostat, the touch keys and backlight will light up.
This can be useful if you need to adjust the set temp or timer in a dark room.
• Press the Tick key once again to pair the thermostat to the Hub ....................
• The MESH symbol appears ashing on the display.
• When the SmartStat successfully connects to the Hub the
MESH symbol will be permanently displayed.
• Press ADD ANOTHER for addtional zones or press FINISH to complete setup.
Please note, you only have to pair the hub to your account once.
To pair any additional Smart Stat, select ZONES, edit, then ADD ZONE.
Smart Series
To Next Page
Loading...
