Polypipe SmartStat - Mode Select

7
SmartStat can either be used as a thermostat or a time clock.
Thermostat mode is the default setting.
To change between thermostat or time clock modes, follow these steps.
• Use the Left / Right keys to scroll to ...........................................................................
• Press and hold the Tick button for 3 seconds ...............................................................
• SETUP will be highlighted, now press and hold the tick key for 10 seconds .....
• Use the Left / Right keys to scroll between modes .....................................................
Mode 1 = Thermostat
Mode 2 = Time Clock
• Press the Tick key to conrm selection ............................................................................
The SmartStat will revert to the main display screen for the selected mode.
For time clock mode instructions, rst pair the time clock with the SmartHub as
explained on page 8, then turn to page 33.
Mode Select
Smart Series