Polypipe SmartStat - Wiring Diagram - SmartStat to Boiler S;L

28
Floor Temperature Sensor Probe Type
Note: This change should only be carried out by an experienced technician who has
accurately veried the probe value being used.
The SmartStat is configured as default for compatibility with 10K sensor probes.
The thermostat is also compatible with two other common probe values which are 12K or 15K.
To change the neoStat to use a dierent probe type, follow these steps;
10 = 10K Probe
12 = 12K Probe
15 = 15K Probe
• Press the Tick key to conrm selection .....................................................................
• Use the Left / Right keys to scroll to ......................................................
• Press and hold Tick to turn the display OFF .........................................................
• Press and hold the Up and Down keys together for 5 seconds ................
• Use the Left / Right keys to scroll between the dierent probe values ......
The SmarStat will revert to the main display configured for the new probe type.
SmartStat