Polypipe SmartStat - Mode 2 - Time Clock

33
Factory Reset
To reset the device to factory default settings, follow these steps:
• Use the Left / Right keys to scroll to
.....................................................................
• Press and hold Tick to turn the display OFF ............................................................
• SETUP will be highlighted ..............................................................................................
• Press and hold the Tick key for 10 seconds .............................................................
• All of the icons on the display will appear for 2 seconds, then you
will see the number 1 or 2 ashing.
• Use the Left / Right keys to scroll between modes (selection will ash) ......
Mode 1 = Thermostat
Mode 2 = Time Clock
• Press the Tick key to conrm selection .....................................................................
The SmartStat will revert to the main display screen for the selected mode.
Note: Factory reset will cancel all parameters that were entered during the set-up and
pairing operations. These processes must be repeated after factory reset is completed.
Smart Series