PolyScience 300 Series User Manual

www.cuisinetechnology.com 1615
PolyScience Vacuum Sealing Systems
1� Pull out a length of roll sized to t the item you wish to vacuum
package� Be sure to allow for at least 1�75 inch (4�5 cm) of space
at the top and the bottom of the food item�
2� Cut the roll to size�
3� Place one end of the cut piece across the seal bar in the
Vacuum Chamber and secure the open end of the vacuum bag
in the bag clamp located in front of the seal bar� Make sure
the seal bar spans the entire width of the roll and that there are
no wrinkles in the bag material�
4� Close the Vacuum Chamber Lid�
5� Press until the Seal Time LED lights�
6� Press the and/or buttons until the desired Seal Time
settings appear on the Digital Display�
7� Press � The Seal Time will count down from the current setting
to 00� Three one-second audible tones will sound when the
sealing process is complete�
8� Open the Vacuum Chamber Lid, remove the bag and check for
proper seal�
!
Making a Heat-Seal Bag from a Roll
NOTE: A positive seal will look “clear” upon
inspection� If the seal is spotty or incomplete,
increase the seal time; if the seal is white or milky,
decrease the seal time�
Vacuum / Seal Preset
1� Press �
2� Press until the LED adjacent to the desired Vacuum Level
lights�
3� Press until the Seal Time LED lights�
4� Press the and/or buttons until the desired setting appears
on the Digital Display� Enter a value of 00 if you want the bag to
remain unsealed�
5� Press and hold the preset button ( , or ) you want to
associate with this vacuum / seal combination for ten seconds�
Two one-second beeps sound and the preset ID (P1, P2, P3)
appears on the Digital Display�
6� Press to run the preset program; press if you do not wish
to run the program at this time (the Digital Display will reset to
00)�
Marinate Preset
1� Press �
2� Press until the LED adjacent to the desired Vacuum Level
lights�
3� Press until the LED adjacent to Marinate Time lights�
4� Press the and/or buttons until the desired Marinate Time
appears on the digital display�
5� If you wish to seal the bag once the marinating process is
complete, press until the LED adjacent to Seal Time lights
then use the and/or buttons to set the desired seal time�
6� Press and hold the preset button ( , or ) you want to
associate with the program for ten seconds� Two one-second
beeps sound and the preset ID (P1, P2, P3) appears on the
Digital Display�
7� Press to run the preset program; press if you do not wish
to run the program at this time (the Digital Display will reset to
00)�

PolyScience 300 Series Specifications

General

Brand	PolyScience
Model	300 Series
Category	Kitchen Appliances
Language	English