Polytec OFV-512 User Manual


)LUVW6WHSV
,QVWDOODWLRQDQG)XQFWLRQDO7HVW
9LEURPHWHUZLWK6HQVRU+HDG2)9
For the installation and an initial functional test of the vibrometer, proceed as
follows:
3UHSDULQJ 1. Make sure that the key switch on the controller is in position O and the
beam shutter on the sensor head is in position OFF.
2. Check the setting on the mains voltage selector on the back of the control-
ler as well as the fuses.
&DEOLQJ 3. Plug the connecting cable into the Sub-D jack CONTROLLER on the back
of the sensor head and into the Sub-D jack INTERFEROMETER on the
back of the controller. Fix the connections with the screws provided.
$OOFRQQHFWLRQVPXVWEHHDV\WRSOXJ LQ,IQRWFKHFNWKHSOXJIRUEHQW
FRQWDFW SLQVWRDYRLGVHULRXVGDPDJHEHLQJLQFXUUHG
4. Use the earthed mains cable to connect the controller to a wall outlet pro-
viding protective grounding.
6ZLW FKLQ JR Q 5. Switch the controller on by turning the key switch to position I.
2QWKHIURQWRIWKHFRQWUROOHUWKH/ (' 32:(5OLJKWV XS3URYLGLQJWKH
FRQQHFWLQJFDEOHKDVEHHQLQVWDOOHGFRU UHFWO\WKH/ (' /$6(5RQWKH
VHQVRUKHDGDOVRO LJKWVXS/DVHUOLJKWLVQRW\HWHPLWWHGDVWKHEHDP
VKXWWHULVVWLOOFORVHG
6. Before now opening the beam shutter, remember the information on laser
safety provided in section 1.1!
7. Open the beam shutter on the sensor head by turning the knob to position
ON.
7KHODVHUEHDPLVQRZHPLWWHGIURPWKHVHQVRUKHDG
7HVW 8. Put a piece of reflective film (enclosed in this manual) at approximately
45cm from the front panel of the sensor head in the beam path.
9. 2)9 : Pull the knob AUTO/MAN out until it clicks into place and turn
the focusing ring until the adjustment mechanism clicks into place.
2)9 : Pull the knob BRAKE ON/OFF out until it clicks into place and
turn the focusing ring until the adjustment mechanism clicks into place.
1RZWKHODVHUEHDPFDQEHIRFXVHG
10. Focus the laser beam on the reflective film using the focusing ring on the
sensor head.
3URYLGLQJWKHVHQVRU KHDGDQGWKHLQSXWVHFWLRQRIWKHFRQWUROOHUDUH
ZRUNLQJFRUUHFWO\WKHVLJQDOOHYHOGLVSOD\ZLOOIXOO\OLJKWXS
11. If you have not been able to observe the effect described under 10., check
the signal level again after 20 minutes. After this warm-up phase the laser
has reached its working temperature (refer also to section 4.2.4).

Polytec OFV-512 Specifications

General

Brand	Polytec
Model	OFV-512
Category	Measuring Instruments
Language	English