Version 2.1
Update: April 2016
PONSEL Mesure – Aqualabo Contrôle
35 Rue Michel Marion – 56850 CAUDAN, FRANCE
Tel.: +33(0)2 97 89 25 30 – Fax: +33(0)2 97 76 55 72
Used to set the number of measurements (from 1 to 50) from which the
moving average is calculated.
This line lets the operator select the primary parameter for sensor 1,
which shall then be displayed in the upper part of the home screen (refer
to item 3 in Table 2). The next window then lets the operator select from
a list of the parameters measured by sensor No. 1 (up to 4 parameters).
This parameter shall be displayed in the upper right-hand corner of the
upper part of the home screen (refer to item 7 in Table 2). The next
window then lets the operator select from a list of the parameters
measured by sensor No. 1.
The measurement range can only be set for the conductivity and turbidity
parameters, as indicated in the table below.
This line is used to select the units in which the temperature parameter
will be displayed (°C or °F).
This line lets the operator select an interval between each measurement
of between 1 and 60 seconds.
The sensors can measure up to 4 parameters, as described below:
Measurement range options
Temperature
Oxygen as a % of saturation
Oxygen in mg/L
Oxygen in ppm
Temperature
pH
Redox in mV
Temperature
Conductivity in µS/cm or mS/cm
Salinity in g/kg
TDS in ppm
Conductivity:
Auto (Automatic range)
0-200 µS/cm
0-2,000 µS/cm
0-20 mS/cm
0-200 mS/cm
Temperature
Turbidity in NTU
Turbidity in FNU
Turbidity in mg/L
Turbidity:
Auto (Automatic range)
0-50 NTU
0-200 NTU
0-1,000 NTU
0-4,000 NTU
Temperature
Conductivity in mS/cm (default parameter)
Salinity in g/kg
Conductivity (not compensated for temperature) in mS/cm
Temperature
Sludge Blanket detection
Temperature
Sludge Blanket detection
Suspended Solid
Turbidity
To Next Page
Loading...