PONSEL Mesure – Aqualabo Contrôle
35 Rue Michel Marion – 56850 CAUDAN, FRANCE
Tel.: +33(0)2 97 89 25 30 – Fax: +33(0)2 97 76 55 72
2. Description of the equipment
2.1 ACTEON 5000 transmitter.
2.1.1 General description.
The ACTEON 5000 digital transmitter can be connected to two digital sensors in the PONSEL
MESURE range to monitor the following parameters: pH, redox, temperature, dissolved oxygen (using
optical technology), conductivity, salinity, turbidity (NTU, mg /L), Suspended Solid, Sludge blanket
detection….
The values measured are displayed and transmitted using analog or digital technology. The
preconfigured regulation functions can be used to optimize the control of processes.
The ACTEON 5000 is used in combination with a wide range of interference-resistant digital sensors,
offering pre-amplification features built into the sensor and digital signal processing. All the data
regarding the calibration, history, users and measurements is processed directly within the sensor,
thus delivering very high levels of traceability and enhancing the reliability of the measurements.
2.1.2 Technical characteristics.
Choice of 2 programmable parameters depending on the sensor connected
Programming in mode PI, PID
Can be set to NO/NC
Setpoint: the measurement range (hysteresis/direction) and activation time can both
be selected,
Control of the external cleaning system
Equipment sensor fault alarm output
To Next Page
Loading...