Page 12 of 23 Visit www.inverx.com.au for more information
2.4 Cleaning the Filter Basket
1. Clean the filter basket after each cleaning cycle. When a cleaning cycle is complete, the robot will stop at the
side of the pool.
2. Use the hook (attached to your telepole) to hook onto the robot’s handle, and lift the robot from the bottom of
the pool to the surface of the pool water. Then use your hands to lift the robot onto the edge of the pool, by
holding it by the handle.
3. Do not lift or carry the robot by the tracks or any other part of the robot. Do not use the hook to lift the robot out
of the water, only use the hook to bring the robot to the surface of the water. The robot is heavier when filled
with water. Pay special attention when lifting it out of the water.
4. Place the robot on the edge of the pool and hold it on an angle to let the water drain out into the pool.
5. Ensure the robot is turned off.
6. Remove the filter basket, then open the basket:
7. Empty any debris and clean the basket with a hose or by running under a tap. Ensure there are no holes
in the basket’s mesh.
Note: There is a risk of being injured by debris if cleaning the filter basket with your hands. It is recommended
to wear thick rubber gloves while cleaning the basket.
To Next Page
Loading...