WARNING
1. To avoid electric shock and other hazards which could result in major injuries, ensure the robot is disconnected
from the charger before performing any cleaning and/or maintenance.
2. Before any maintenance, be sure to insert the magnetic cap underneath the robot to prevent any parts from
moving and causing injury.
3.1 Filter Maintenance
1. Clean the filter after each cleaning cycle to ensure optimum cleaning and climbing performance. Refer to
Section 2.3 for filter cleaning instructions.
2. Annually clean the filter with mild acidic detergent. Safety equipment must be worn when carrying this out.
3.2 Impeller Maintenance
If you have any difficulties performing impeller maintenance, please contact your authorised dealer for
assistance.
1. Ensure the robot is turned off and the magnetic safety cap is inserted underneath the robot.
2. Take out the filter box.
3. Remove the 2 housing screws and take off the housing.
4. Remove the styrofoam insert.
5. The impeller has sharp edges, please ensure you wear protective gloves while handling the impeller.
6. Remove the 4 x impeller cover screws and take off the impeller cover.
To Next Page
Loading...