CAUTION
To prevent possible damage to the robot, injury to people or voiding your warranty, please follow these
guidelines:
• Use the hook (attached to your telepole) to lift the robot from the bottom of the pool to the surface of the
pool water. Then use your hands to lift the robot onto the edge of the pool, using the robot’s handle. Do not
lift or carry the robot by the tracks or any other part of the robot.
• Do not use the hook to lift the robot out of the water, only use the hook to bring the robot to the surface of
the water.
• The robot is heavier when filled with water. Place the robot on the edge of the pool and hold it on an angle
to let the water drain out into the pool.
• After cleaning is completed, ensure robot is fully dry and store the robot in an undercover cool dry place
away from direct sunlight.
Once you have selected the operating settings on the robot, place the robot into the pool water (we
recommend the corner of the pool) within 3 minutes, otherwise the robot will enter Sleep mode. If the robot
has entered Sleep mode, hold the button for 3 seconds to turn the robot on, and re-select your
settings.
Clean the filter basket after each cleaning cycle. Avoid cleaning the surface of the filter box directly with
your hands.
When placing the robot into the pool water, ensure it is fully
submerged, then gently tilt the robot slightly in all directions
to ensure any air contained in the robot is released.
To Next Page
Loading...