Pool Pro X30 - Page 20

Page 20 of 23 Visit www.inverx.com.au for more information
Problem
Possible Cause
Solution
Robot not
moving or
pumping water
Low battery
Charge the robot (Refer to Section 2.5)
Robot is not submerged in enough
water
Ensure the robot is submerged under a minimum of
40cm of water, and ensure the robot is turned on
Power button was not pressed after
selecting settings
Press the power button after you have selected the
settings. Ensure the correct lights are on before putting
the robot into water
Filter basket is full
Clean the filter basket (Refer to Section 2.4)
Robot is
moving but not
pumping water
The impeller is stuck
Check and clean the impeller (Refer to Section 3.2)
Filter basket is full
Clean the filter basket (Refer to Section 2.4)
Water inlet is blocked
Remove the filter basket and clean the water inlet
(Refer to Section 2.4)
Battery low
Charge the robot (Refer to Section 2.5)
Robot is
pumping water
but not moving
The drive motor is stuck
Please contact your authorised dealer for replacement
Track belt is deviated and stuck
Turn the robot on its side and roll the track forward and
backward to restore the track. Repeat on the other track
Track belt is damaged
Replace track belt (Refer to Section 3.4)
Brushes are stuck
Ensure there are no obstacles or debris stuck in the
brushes/rollers
The robot gets stuck by an obstacle
and shuts down for auto-protection
Remove obstacle and restart the robot
Filter basket is full
Clean the filter basket (Refer to Section 2.4)
Robot is not
climbing
Robot is set to floor cleaning mode
only
Set the robot to the overall cleaning mode
The impeller is stuck
Clean the impeller (Refer to Section 3.2)
Filter basket is full
Clean the filter basket (Refer to Section 2.4)
Water inlet is blocked
Remove the filter basket and clean the water inlet (Refer
to Section 2.4)
Poor cleaning
capability
Battery is low
Charge the robot (Refer to Section 2.5)
The impeller is stuck
Clean the impeller (Refer to Section 3.2)
Filter basket is full
Clean the filter basket (Refer to Section 2.4)
Water inlet is blocked
Remove the filter basket and clean the water inlet (Refer
to Section 2.4)
Brushes are damaged
Replace the brushes (Refer to Section 3.3)
Filter basket is damaged
Replace the filter basket
Robot is not
behaving
correctly
Software failure
Reset the robot by inserting the magnetic safety cap
underneath the robot for 5 seconds, then remove it and
restart the robot