REV. 032017
22
Clean the cabinet’s refrigeration unit and the condenser at least once a year. Unfasten
the restraint band from the top edge at the back of the unit and move the cabinet away
from the wall. Annually clean any dust and other dirt from the compressor section and the
condenser located in the back of the cabinet.
Use the brush attachment of a vacuum cleaner to clean the unit. Dirt in the compressor
section and on the condenser impair the unit’s function and increase power consumption.
Clean the cabinet door gasket using a mild water-soluble detergent and check the con-
dition of thegasket. Change if there is visible damage or wear. A silicone spray makes the
gaskets flexible and dirt-rejecting.
Cleaning in a dishwasher is not recommended for the loose parts of the equipment. Put
back all removed parts and switch the equipment on.
Ensure that the temperature has reached the set
point temperature before loading the cabinet with
products again
Clean condenser (Promed MC70, 180,
150/150 models):
• Vacuum the condenser with careful up-and-down
stokes (B)
Clean condenser (Future MC, MF520,
720, 722, 1422 models):
• Vacuum the condenser with careful up-and-
down strokes (B)
Clean condenser (option Future MC,
MF, Reversed cooling unit):
• The condenser is behind the control panel
• Loosen two screws on the lower part of the
panel (A).
• Open the panel and vacuum the condenser
with careful up-and-down strokes (B).
To Next Page
Loading...
