Posey KeepSafe Essential - Preparing the Keepsafe Essential for Use

www.posey.com 1.800.447.6739
KeepSafe Essential
10
Preparing the KeepSafe Essential for Use
Battery Installation:
The battery-operated KeepSafe Essential is portable and long lasting.
Fresh alkaline batteries have an estimated life of 30 days of daily use.
Actual life depends on alarm mode, tone and volume you select.
Alarm will “chirp” about every 15 sec
-
onds when new batteries are needed.
Change batteries at once.
1. If your alarm does NOT have an ON/
OFF switch (Cat. 8373NP), connect a
magnet before inserting the batteries.
If your alarm DOES have an ON/
OFF switch (Cat. 8373), slide the
power switch to the OFF position before
inserting/changing batteries.
2. Press down on the arrow and slide
the battery compartment door
completely off (Fig. 1). Set battery
door aside.
3. Drape the red ribbon across the
battery compartment and insert four
(4) new “AAA” batteries as pictured
inside the battery compartment
(Fig. 2). Take care not to damage
battery contacts. Batteries should be
inserted on top of red ribbon and the
loose end of the ribbon should stick
out the other end for easy battery
removal (Fig. 3).
4. Lay the loose end of the red ribbon
on top of the batteries and reattach
the battery compartment door. Slide it
shut, locking it into place.
Fig. 2
Fig. 1
Fig. 3
PREPARING