Page 14
Securing your Access Point
To ensure the PosiTector is only accessible to authorized devices, it is important that
you enter a passphrase (password) for the Access Point. The default Passphrase is
password.
In the Connect > WiFi > Setup menu, select AP Passphrase to modify the default
passphrase.
Enabled
Select to allow connection with your local WiFi network. The WiFi icon will appear on
the display and the Gage will attempt to connect to any previously configured network.
Connect to a new network from the Networks menu option.
Networks
Searches and displays all available WiFi networks within range. Select a network, then
enter the password, if required. The WiFi icon will appear on the display.
NOTE:
Some networks may not be visible and will require manual configuration using
the Add Network option. See your network administrator or IT department for
assistance.
WiFi Information
Displays information about the local WiFi network connection including:
SSID:
the network’s name
State:
the network connection status
IP Address:
the assigned IP Address for the Gage on the network
Sync .net Now
When selected, the Gage immediately synchronizes stored measurement data to
PosiSoft.net (WiFI internet connection required).
To Next Page
Loading...
Need help?
General