PRK-8000 Operation Manual
- 21 -
will not light until the center is measured properly.
Change to MANU Mode as required.
[MANU Mode]
You can enter MANU Mode by pressing the touch screen. As you select one from eight
target positions, the position of blinking target changes. Select the target, perform
alignment and focusing, and measure.
z Only the value of the last measurement will be displayed on the monitor. You
cannot see any one of the previous measurements even if you select the target
which has already been measured by pressing the touch screen. Enter DISPLAY
Mode if you wish to see the result of measuring other parts. (See chapter 6)
NOTES:
① Once you have entered MANU Mode, you must end the measurement, press
PRINT button, and start a new measurement in order to return to AUTO Mode.
② Eccentricity (“E” and “EQ”) will not be calculated unless the center of cornea
is mesured.
(4) Repeat the measurement as required.
Measure the same eye for a second time as required.
(5) Measure the other eye.
Measure the other eye in the same manner.
To Next Page
Loading...
