Potec PRK-8000 - 3.2 Operation Panel Overview; Chinrest Lever and Touch Screen; Measurement Mode Buttons; Function and Control Buttons

PRK-8000 Operation Manual
- 5 -
3.2 Operation Panel
CHINREST LEVER Touch Button
CHINREST
LEVER
This Lever is for raising/lowering the chin rest. Press “up” lever in order to raise and “down”
lever to lower the chin rest.
Press this button in order to change
measurement mode.
Press this button in order to enter
DISPLAY Mode, where you can
see measurement data stored in
memory
Press this button in order to start manual
or automatic measurement.
- -
Press this button in order to OFF/ON
semi-automatic eye tracking
Press this button in order to change
CYL form.
Press this button when the examinee’s
eye is difficult to measure due to cataract
or examinee with intraocular lens (IOL).
Press this button in order to enter
SIZE Mode, where you can measure
the diameter of cornea, etc.
Press this button in order to enter RET
(Retroillumination) Mode, where you can
observe the image obtained by
retroillumination.
Press this button to clear all stored
data in memory.
Press this button in order to print or
transfer the measurement.
Press this button in order to enter
SETUP Mode, where you change all
the settings about measurements,
printouts etc.