PFC-4064 KEYPAD PROGRAMMING • 8870080 • REV A • 12/17
Section 1: Introduction
The PFC-4064 Conventional Fire Panel is a compact, expandable panel designed to monitor all facets of a re alarm system
and communicate the status to a monitoring station. The PFC-4064 panel is a listed and approved microprocessor based
conventional re panel and complies with UL-864, NFPA-70, and NFPA-72.
Purpose Of This Manual
This manual is intended to assist in the programming of the PFC-4064 Conventional Fire Panel via its keypad. Refer to this
manual to properly program the PFC-4064. It is recommended that the user follows the procedures as outlined in this manual
to assist in proper programming and prevent damage to the control panel and associated equipment.
System Overview
The PFC-4064 system is designed for use as a re control panel for life safety applications.
System Features
The PFC-4064 has six (6) programmable input circuits, and is expandable to 192 using thirty-one (31) IDC-6 cards, each
providing six (6) additional programmable input circuits.
Four (4) Notication Appliance Circuits (NAC) rated at 3.0A maximum
Power Limited
Built in Sync
Cadence and Temporal Patterns
Programmable to activate on a Supervisory condition
Support for all major strobe synchronization patterns.
Gentex®
AMSECO®
Wheelock®
System Sensor®
Auto Silence and Silence Inhibit.
Built-in Ethernet port for programming and network connectivity.
Built-in Email support to communicate system status and event information.
Customizable Reminder Emails.
4,000 event non-volatile history buffer
99 Software Zones
4 X 20 character LCD display
Built-in IP Reporting
How To Use This Manual
Refer to this manual before contacting Technical Support. The information in this manual is the key to a successful
programming and will assist you in understanding proper system start up, device designation, and other guidelines specic to
the PFC-4064 system.
1
To Next Page
Loading...
