Power Acoustik PD-710 - AV-IN Mode; Setting Control; Sound Control

16
◆AV-IN Mode
To start AV-IN Mode, tap on AV-IN button from
main menu screen.
Connect the external audio/video signal source to this
unit. Select AV-IN mode in the main menu or by
pressing repeat Mode button on the front panel.
Note: If there is no external video input, the TFT
displays “NO SIGNAL”.
Press the icon to be back to main menu.
◆SETTING CONTROL
Your device has default system settings. You can customize the settings to suit your
personal needs. Once you change settings, your new settings will remain until you change it
again. To start SETTING, tap it on button from main menu screen.
SOUND CONTROL
Tap SOUND button to show SOUND1 menu.
Tap button to show SOUND 2 menu.
EQUALIZER
Select EQ mode
BASS
Bass up/down
TREBLE
Treble up/down
BALANCE
Left/Right Balance Control
FADER
Front/Back Fader Control
BEEP
Keypad sound setting on or
off
LOUDNESS
Set LOUD ON/OFF
SUBWOOFER
Set SUBWOOFER ON or
OFF