Why is the image blurred, distorted, or dark on my Power Acoustik Car Receiver?
If the image on your Power Acoustik Car Receiver is blurred, distorted, or dark, it could be because the disc is illegally copied. Use an original disc.
Why does my Power Acoustik Car Receiver reset when the engine is off?
If your Power Acoustik Car Receiver resets itself when the engine is off, there may be an incorrect connection between the ACC and positive battery wire. Check the wiring and correct it.
What to do if my Power Acoustik Car Receiver has no or low audio output?
If you're experiencing no or low audio output from your Power Acoustik Car Receiver, the possible causes are: improper audio output connection, volume set too low, damaged speakers, heavily biased volume balance, or speaker wiring in contact with metal parts of the car. Check the wiring and correct it if necessary. Increase the volume level. Review the wiring diagram and check the MUTE connection. Replace the speakers if damaged. Adjust the channel balance to the center position. Insulate all speaker wiring connections.
What to do if my Power Acoustik PTID-8940N shows no image?
If your Power Acoustik Car Receiver is displaying no image, it could be due to an incorrect connection to the parking brake wire, or PARKING is activated but the parking brake is not engaged. Check the wiring and correct it if necessary. If safe, stop the vehicle and apply the parking brake.
Why does the remote control not work on my Power Acoustik Car Receiver?
If the remote control for your Power Acoustik Car Receiver isn't working, the battery may be depleted or installed incorrectly. Replace the battery with a new one, or remove the battery and install it correctly.
What does 'Error' mean on my Power Acoustik PTID-8940N?
If your Power Acoustik Car Receiver displays an 'Error' message, it indicates an illegal mechanism operation. Press the EJECT key for 5 seconds to reset the loading mechanism.
What does 'No disc' mean on my Power Acoustik Car Receiver?
If your Power Acoustik Car Receiver displays a 'No disc' message, the disc may be dirty, inserted upside down, or simply not present in the loading compartment. Clean the disc with a soft cloth, insert it with the label side up, or insert a disc if the loading compartment is empty.
What does 'Bad Disc' mean on my Power Acoustik Car Receiver?
If your Power Acoustik Car Receiver displays a 'Bad Disc' message, the disc may be dirty or inserted upside down. Clean the disc with a soft cloth and ensure it is inserted with the label side up.
How to make the monitor open automatically on my Power Acoustik Car Receiver?
If the monitor on your Power Acoustik Car Receiver does not open automatically, the TFT Auto Open feature may be turned off. Turn the TFT Auto Open feature on.
How to fix prolonged image or improper height/width ratio display on my Power Acoustik PTID-8940N Car Receiver?
If you're experiencing a prolonged image or improper height/width ratio display on your Power Acoustik Car Receiver, it could be due to improper video signal connections or an improper aspect ratio setup. Check the wiring and correct it. Use the correct aspect ratio setting.
General| Touchscreen | Yes |
|---|---|
| Resolution | 800 x 480 pixels |
| Bluetooth | Yes |
| Radio Tuner | AM/FM |
| Rear Camera Input | Yes |
| Navigation | No |
| DVD Player | Yes |
| SD Card Slot | Yes |
| Steering Wheel Control Compatible | Yes |
| AUX Input | Yes |
| GPS Navigation | No |
| Audio Formats Supported | MP3, WMA |
| Video Formats Supported | MP4, AVI |
| Power Output | 50 Watts x 4 |
To Next Page