How to improve weak station searching on my Power Acoustik PTID-8940N?
If you're experiencing weak station searching on your Power Acoustik Car Receiver, the auto antenna may not be fully extended or properly connected, or the LOCAL function is activated. Connect the auto antenna control cable properly and turn the LOCAL function off.
What to do if a disc does not play back in my Power Acoustik Car Receiver?
If a disc isn't playing back in your Power Acoustik Car Receiver, it could be warped, scratched, dirty, wet, incompatible, or inserted upside down; or its rating exceeds the Parental Lock limit, or its region code is incompatible. Use a disc in good condition, or clean it with a soft cloth. Use a compatible disc and change Parental Lock settings to a lower restriction if needed. Use a disc with the proper region code and insert the disc with the label side up.
How to resolve poor sound quality or distortion in my Power Acoustik Car Receiver?
If you're experiencing poor sound quality or distortion with your Power Acoustik Car Receiver, it could be due to using a pirate disc, speaker power rating not compatible with the unit, or a shorted speaker. Use an original disc. Connect proper speakers. Check the speaker contact.
Why does the remote control not work on my Power Acoustik Car Receiver?
If the remote control for your Power Acoustik Car Receiver isn't working, the battery may be depleted or installed incorrectly. Replace the battery with a new one, or remove the battery and install it correctly.
What to do if my Power Acoustik PTID-8940N shows no image?
If your Power Acoustik Car Receiver is displaying no image, it could be due to an incorrect connection to the parking brake wire, or PARKING is activated but the parking brake is not engaged. Check the wiring and correct it if necessary. If safe, stop the vehicle and apply the parking brake.
What to do if my Power Acoustik Car Receiver has no or low audio output?
If you're experiencing no or low audio output from your Power Acoustik Car Receiver, the possible causes are: improper audio output connection, volume set too low, damaged speakers, heavily biased volume balance, or speaker wiring in contact with metal parts of the car. Check the wiring and correct it if necessary. Increase the volume level. Review the wiring diagram and check the MUTE connection. Replace the speakers if damaged. Adjust the channel balance to the center position. Insulate all speaker wiring connections.
Why does my Power Acoustik Car Receiver reset when the engine is off?
If your Power Acoustik Car Receiver resets itself when the engine is off, there may be an incorrect connection between the ACC and positive battery wire. Check the wiring and correct it.
General| Touchscreen | Yes |
|---|---|
| Resolution | 800 x 480 pixels |
| Bluetooth | Yes |
| Radio Tuner | AM/FM |
| Rear Camera Input | Yes |
| Navigation | No |
| DVD Player | Yes |
| SD Card Slot | Yes |
| Steering Wheel Control Compatible | Yes |
| AUX Input | Yes |
| GPS Navigation | No |
| Audio Formats Supported | MP3, WMA |
| Video Formats Supported | MP4, AVI |
| Power Output | 50 Watts x 4 |
To Next Page