Why does flashing image or interference appears on Power Acoustik Car Receiver screen?
A flashing image or interference on your Power Acoustik Car Receiver screen can occur if the DVD is not compatible with the current TV system settings. Change the setup to accommodate the disc.
Why Power Acoustik PTID-8940NRBT Gen 2 unit resets itself when engine is off?
If your Power Acoustik Car Receiver resets itself when the engine is off, it might be due to an incorrect connection between the ACC and positive battery wire. Check the wiring and correct it.
What to do if Power Acoustik Car Receiver unit blows fuse?
If your Power Acoustik Car Receiver keeps blowing fuses, it could be due to the yellow or red wire touching the chassis ground (check for pinched wire), speaker wires touching the chassis ground (check for pinched wire), or using an incorrect fuse rating (use a fuse with the correct rating).
What to do if Power Acoustik PTID-8940NRBT Gen 2 Car Receiver has power but no or low audio output?
If your Power Acoustik Car Receiver has power but you're not getting any or enough sound, check the speaker wire connections at the speakers. Also, make sure that none of the speaker wires are touching each other or the chassis ground; if they are, insulate all bare speaker wires. Finally, review the wiring diagram and check if the speakers are damaged.
Why Power Acoustik Car Receiver has poor sound quality or distortion?
Poor sound quality or distortion in your Power Acoustik Car Receiver can occur if the speaker power rating is not compatible with the unit (connect proper speakers) or if a speaker is shorted (check speaker wire contact).
Why Power Acoustik PTID-8940NRBT Gen 2 IR remote does not work?
If the IR remote for your Power Acoustik Car Receiver isn't working, the battery might be dead (replace the battery) or installed incorrectly (remove the battery and install it correctly).
Why Power Acoustik Car Receiver cannot insert disc?
If your Power Acoustik Car Receiver won't let you insert a disc, it's possible that there's already a disc inside the unit. Eject the current disc and then insert the new one.
Why Power Acoustik PTID-8940NRBT Gen 2 Car Receiver image is blurred, distorted, or dark?
If the image on your Power Acoustik Car Receiver is blurred, distorted, or dark, it could be because the disc is illegally copied. Use an original disc.
Why Power Acoustik PTID-8940NRBT Gen 2 DVD does not start playback?
If your Power Acoustik Car Receiver DVD doesn't start playback, it could be due to several reasons: the disc is warped or scratched (use a disc in good condition), dirty or wet (clean disc with soft cloth), incompatible (use compatible disc), the disc rating exceeds the Parental Lock rating limit (change parental lock settings to lower restriction), disc region code is not compatible with the unit (use disc with proper region code), or the disc is inserted upside down (insert disc with label side up).
Why Power Acoustik PTID-8940NRBT Gen 2 Car Receiver has excessive skipping?
Excessive skipping on your Power Acoustik Car Receiver could be due to the unit not being mounted correctly (check mounting sleeve) or a physical defect in the media (check media for scratches).
General| Brand | Power Acoustik |
|---|---|
| Model | PTID-8940NRBT Gen 2 |
| Category | Car Receiver |
| Language | English |
Guides on calibrating the touch screen for accurate input.
Covers configuration options for Bluetooth connectivity and pairing.
Covers common issues like power, fuses, and wiring.
Addresses problems related to radio reception and antenna.
Deals with display issues, front panel operation, and image problems.
Covers issues related to disc insertion, playback, and media errors.
To Next Page