Power SUA2000iD - Parallel Operation; Parallel Operation Setup and Use

Page 20
Parallel Operation (2 x SUA2000iD Models)
NOTE:
Only connect two identical (same model) generators
together for parallel operation.
Paralleling this generator to a generator that is not
compatible can cause a low voltage output that can
damage tools and appliances powered by the
generator. Do not connect or disconnect parallel
cables while the generator is running to avoid damage.
Parallel operation gives you the ability to link this
generator to a compatible AIPOWER generator for
combined running and starting power output. Use
only the AIPOWER approved cables for parallel
operation. For single generator operation, the parallel
operation cable must be removed.
NOTICE
WARNING
Fire and electrocution hazard. Never connect or
disconnect the parallel cord leads when a generator
is running. Do not parallel more than two generators.
Use only AIPOWER generators for paralleling.
2. Stop the engine (generator). See the “Stopping the
Engine (Generator)” section for stopping procedure.
3a. Gasoline to Propane/LPG
3b. Propane/LPG to Gasoline
• Fully open the Propane/LPG cylinder knob.
• Make certain the propane tank is fully closed.
• Turn the fuel source switch to the gasoline
position.
4. Start the engine (generator). See the “Starting the
Engine (Generator)” section for starting procedure.
• Turn the fuel source switch to the propane/LPG
position.