At this point you are requested to swing
the model’s tail to left or right: the rudder
should immediately deflect in response to
this movement. Here again: if the rudder
does not respond, briefly jerk the model’s
tail once to left or right, so that the sensor
switches to the correct axis.
Now hold the model’s tail far enough to
left or right to cause the bar to move to full
deflection, and wait until the rudder jumps
back to the neutral position. This concludes
the procedure.
The iGyro now automatically activates
Heading mode, as this displays the gyro’s
effect in the clearest fashion. At this point
it is essential to check the direction of ef-
fect of the control surfaces: if the directi-
on of effect is incorrect, move the cursor
to the appropriate channel and press the
SET button to reverse the direction. Please
take particular care, and work conscien-
tiously here - don’t rush it!
Once all the control surfaces are set up
correctly, select OK: the iGyro is now disa-
bled again.
The basic settings are now complete, and you can
fly the model using the TESTFLY ASSISTANT.
To Next Page
Loading...
Need help?
General
