Important Information on the PMaC P1000
In the event of a site having no permanent mains supply it is still possible to set up and commission the curtain. The P1000 has a built in battery pack which is capable of
operating the motor without mains being available. Where it is known beforehand that a permanent mains supply is not available, before visiting site the P1000 should be
given a full charge for approx 7 hours. To do this connect a temporary mains feed and fit the battery fuse. Once charge has been completed remove the battery fuse.
Useful Information P1000
Working Temp -15 to +50 C
Other Information
Standby time
Dimensions 460x306x130mm
Internal Voltage 24V
Panel Batteries 2 x 12v 3.2 AH or equivalent
Environment
IP Rating IP50
Key Number
Humidity 20 - 90% Non Condensing
Enclosure to be sited in dry location
Supply Voltage
Panel Supply Voltage 90-264Vac 47-63Hz Input. Fused 5A
Material Steel
Enclosure
To Next Page
Loading...