Auto Reset
Mains Monitor
Mains Switch
Obstruct. Warn
Obs. Warn Time
The Mains Switch if enabled will turn the system into sleep mode if the Mains Monitor has closed the curtain. To wake up the
system requires a double operation on one of its inputs.
Press the Up or Down buttons to select either “Enabled” or “Disabled”
Press the Up or Down buttons to select either “Disabled”, “Sounder Only” or “Prevent Close”
To set the length of time the OSE beam has to be broken before the panel reacts. For operation refer to OSE operation
flowchart.
Press the middle button to store
The set time before the curtain closes automatically after a mains failure has been detected
Press the Up or Down buttons until the desired time is highlighted
To automatically reset the system after an alarm signal has cleared. For operation refer to alarm operation flowchart
Options: Enabled or Disabled
Press the middle button to enter menu
Press the Up or Down buttons to select either “Enabled” or “Disabled”
To determine what happens when the OSE photo beam is broken (after the time set in Obs. Warn has elapsed) For operation
Press the middle button to store
Press the middle button to store
refer to OSE operation flowchart
Options: Enabled or Disabled
Press the middle button to enter menu
Press the middle button to enter menu
Range 0 - 3 Hours (0 hours = disabled)
Press the middle button to store
Press the middle button to enter menu
Press the middle button to store
Range: 0 - 30 Minutes
Options: “Disabled”, “Sounder Only” or “Prevent Close” (Prevent close will stop curtain closing via key switch immediately upon
detection with sounder after OBS.Warn time elapsed - Prevent Close does not apply to alarm)
Press the middle button to enter menu
Press the Up or Down buttons until the desired time is highlighted
Basic Programming of P1000 - Menu Setting
To Next Page
Loading...