Close Wait
continued ......
Sec. Alarm
E. Retract Op.
E. Retract Time
E. Retract Hold
Operation
P1000 has a secondary alarm input for local alarm activation. For further details refer to alarm operation flowchart.
Press the Up or Down buttons to select either “Enabled” or “Disabled”
Press the middle button to enter menu
Options Enabled or Disabled
Press the Up or Down button until Smoke Curtain is highlighted
To set the time that the curtain retracts for when the emergency retract operation is set to “Timed”
Press the Up or Down buttons to select either “Repeat Alarm”, “Timed” or “Push To Operate”
Press the middle button to store
Smoke Curtain - Curtain remains in stage 2 position indefinitely or until Alarm 2 is triggered
Press the middle button to store
Press the middle button to enter menu
To set the way that the emergency retract operates upon alarm closure. For further details refer to alarm operation flowchart.
Options - Repeat Alarm, Timed or Push to Operate
Press the middle button to enter menu
Press the middle button to store
Range 0 - 2 Minutes
Press the middle button to enter menu
Press the middle button to store
Press the middle button to enter menu
Press the middle button to store
To set the time that the curtain waits before closing after “E. Retract Time” has expired
Press the Up or Down buttons until the desired time is highlighted
To set the operation of the curtain from the key switch inputs
Options - Latched or Push to Run
Range 0 - 2 Minutes
Press the Up or Down buttons until the desired time is highlighted
Press the Up or Down buttons to select “Latched” or “Push To Run”
Press the middle button to store
Press the middle button to enter menu
Basic Programming of P1000 - Menu Setting
To Next Page
Loading...