10
9. DO NOT increase force adjustment to compensate for a damaged gate. The
gate should always be maintained to operate manually as easily as possible to
provide maximum protection.
10. Check all safety systems at least once per month for the correct force, speed
and sensitivity. Gate must reverse when hitting a rigid object, or when a
non-contact sensor is activated. If these functions are observed to operate
improperly, discontinue use and have it serviced immediately!
11. You are responsible for ensuring that warning signs are installed and
maintained on both sides of your gate.
12. To ensure safe operation of this equipment, you must read this safety manual
and keep it for reference.
13. Swing gates have two potential entrapment zones you must avoid. Make sure
they are protected as shown in Figure 1.
4’
MINIMUM
▲
▲
▲
▲
▲
To Next Page
Loading...
