9
END USER SAFETY WARNINGS
The manufacturer of the gate operator does not know what type of gate you have, or what
type of automatic system is installed on your gate. Be sure you’ve been fully instructed
on the sequence of operation for your specic gate system(s). Keep the gate properly
maintained and have a qualied service person make repairs.
1. Be sure the following safety instructions
are distributed to all persons authorized
to use your gate.
2. KEEP GATEWAY CLEAR (Front and
Back) AT ALL TIMES. Your automatic
gate is not for pedestrian use. No
one should ever cross the path of the
moving gate.
3. DO NOT allow children to play near your
gate, or to operate the gate.
4. DO NOT operate your gate system
unless you can see it when the gate
moves.
5. Be sure a pushbutton or key switch
has been installed for manual electric
operation in the event your radio or
card key does not work. Any mounted
control station should be located a
minimum of 10 feet from the gate so
the gate cannot be reached through or
touched. Any pushbutton located in a
building should be installed within sight
of the gate.
6. DO NOT operate any controls without
watching the movement of the gate.
7. Your gate system is required to have a
primary and a secondary entrapment
safety system installed and maintained.
8. If your gate closes automatically, loop
detectors should be installed to detect
the presence of a vehicle.
▲
▲
▲
▲
▲
▲
▲
▲
To Next Page
Loading...
