2
IMPORTANT SAFETY INSTRUCTIONS:
Please reserve this manual for future review.
This manual contains all safety, installation, and operation instructions for
the Tracer-AN series MPPT solar controller (“controller” referred to in this
manual).
• Read all the instructions and warnings carefully in the manual before
installation.
• No user-serviceable components inside the controller; please do not
disassemble or attempt to repair the controller.
• Mount the controller indoors. Avoid exposure to the components and
do not allow water to enter the controller.
• Install the controller in a well-ventilated place; the controller’s heat sink
may become very hot during operation.
• It is suggested to install appropriate external fuses/breakers.
• Make sure to switch o all PV array connections and the battery fuse/
breakers before controller installation and adjustment.
• Power connections must remain tight to avoid excessive heating from a
loose connection.
• The entire system should be installed by professional and technical
personnel.
Explanation of Symbols
• To enable users to use the product eciently and ensure personal
and property safety, please read related literature accompanying the
following symbols.
• Please read the literature accompanying the following symbols.
Symbol Definition
TIP TIP: Indicates any practical advice for reference.
!
IMPORTANT: Indicates a critical tip during the operation, if
ignored, may cause the device to run in error.
CAUTION: Indicates potential hazards, if not avoided, may
cause the device damaged.
WARNING: Indicates the danger of electric shock, if not
avoided, would cause casualties.
WARNING HOT SURFACE: Indicates the risk of high tem-
perature, if not avoided, would cause scalds.
i
Read the user manual carefully before any operation.