INSTRUCTIONS PW220/PW230 23
3.2 Transmitter Memorizing and Erasing Process
RF Transmitter Memorizing & Erasing
1.1.1 Press button SW2 for 1 second, the blue LED light on the receiver board will be on and receiver module will be
changed to “Learning Mode” for 10 seconds. During the period of learning mode, press the left button on the
transmitter, then the transmitter can be memorized by receiver module. (Up to 200 different transmitter can be
memorized) The blue light on the receiver board will blink twice after pressing the button on the transmitter. The
blue light on the receiver board will go off when the transmitter memorizing is done.
1.1.2 The memory can be cleared completely if the SW2 (code learning) is pressed continuously for 10 seconds after the
blue light.
Self-Learning mode for gate operation systems
Step1:
Connect the wires of two motors with terminal M1+/M1- & M2+/M2-
Step2:
Connect 230VAC with terminal J1 and battery with J2.
Setp3:
In single leaf installation, just connect the motor wires with terminal M1+/M1-
Step4:
Press SW2 button for more than 1 second and the blue light on the receiver board
After pressing the left button, system learning will be executed step by step as follows:
1. Dual Gate:
Slave Gate Close → Master Gate Close → Master Gate Open → Slave Gate Open →
To Next Page
Loading...
Need help?
General
