Powervar ACDEF2000-11 User Manual

63 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

A01-00040 Rev. E

POWERVAR Sinergy III Rackmount / Tower User Instruction Manual

Sinergy III 120 Volt UPS

· ACDEF700-11 700 VA UPS

· ACDEF1000-11 1000 VA UPS · E024-12 External Battery Cabinet

· ACDEF1500-11 1500 VA UPS · E036-12 External Battery Cabinet

· ACDEF2000-11 2000 VA UPS · E048-12 External Battery Cabinet

· ACDEF3000-11 3000 VA UPS · E072-12 External Battery Cabinet

Sinergy III 200-240 Volt UPS

· ACDEF2000-22 2000 VA UPS · E048-12 External Battery Cabinet

· ACDEF3000-22 3000 VA UPS · E072-12 External Battery Cabinet

This manual contains important instructions for the Sinergy III UPS and External Battery

Cabinets. Follow these instructions during the unpacking, installation, and maintenance of the

UPS and the External Battery Cabinet. If you have a problem with the UPS or the battery

cabinet, please refer to this manual before calling technical support.

POWERVAR

1450 South Lakeside Drive

Waukegan, IL 60085-8301

T (847) 596-7000

(800) 369-7179

F (847) 596-7100

www.powervar.com

Table of Contents

Questions and Answers:

W
wagnerandrewAug 6, 2025
Why is my Powervar ACDEF2000-11 UPS beeping and overloaded?
- J
  Johnathan CunninghamAug 6, 2025
  If the icon and are flashing, a warning code appears on the LCD, and the alarm beeps twice every second, it indicates that the Powervar UPS is overloaded. This may be because the UPS is genuinely overloaded or, after repetitive overloads, the UPS is locked in bypass mode. To resolve this, remove excess loads from the UPS output. If the UPS is in bypass mode, also shut down the UPS and restart it.
J
Julie MarksAug 11, 2025
What to do if Powervar ACDEF2000-11 shows fault code 43?
- J
  Jacqueline HahnAug 11, 2025
  If fault code 43 and the icon appear on the LCD display and the alarm beeps continuously, it means the UPS shut down automatically due to an output overload. To fix this, remove some of the load from the UPS output and restart the UPS.
E
Eric CunninghamAug 16, 2025
What to do if Powervar UPS shows fault code 14?
- L
  Laura WilcoxAug 16, 2025
  If fault code 14 and the icon appear on the LCD display and the alarm beeps continuously, it means the UPS shut down automatically due to a short circuit on the output. You should check the output wiring and connected devices for a short circuit and remove it.

Powervar ACDEF2000-11 Specifications

General

Model	ACDEF2000-11
Category	UPS
Input Voltage	120V
Output Voltage	120V
VA Rating	2000 VA
Wattage	1400 W
Output Frequency	60 Hz
Waveform Type	Sine wave
Battery Type	Sealed lead acid
Battery Recharge Time	4 hours
Communication Ports	USB
Input Voltage Range	90-140V

Related product manuals

Preview: Powervar ACDEF700-11

Powervar ACDEF700-11

Powervar ABCEG401

Powervar E240-22-A

Preview: Powervar AMETEK 3300 Series

Powervar AMETEK 3300 Series

Preview: Powervar Security Plus

Powervar Security Plus

Powervar 3200 Series