2
1.5.2 General Warnings
CAUTION: POWERVAR considers the safety of personnel to be of paramount importance. For this
reason it is essential that procedures relating to safety in this manual be carefully reviewed before
commencing work , and properly adhered to later. The user or operator may intervene in the opera-
tion of the UPS provided that the instructions laid out in Section 3 “ Installation” are
strictly followed.
CAUTION: Even when all switches and/or circuit breakers are open, dangerous voltages are
present within this unit! There are no user-serviceable parts inside. Only factory authorized technical
personnel may carry out any operation that requires protection panels to be opened and/or removed.
Any repairs or modifications by the user may result in out-of-warranty repair charges, unsafe electrical
conditions, or violation of electrical codes.
1.5 Safety
1.5.1 Safety Intended Use
·
This device serves as an uninterruptible power supply for connected loads. The device is in compli-
ance with all relevant safety regulations concerning information technology equipment for use in
an office environment.
· Depending on the type and rating of UPS device, certain configurations of battery extensions may
be connected. These battery extensions may only be connected to the compatible basic UPS unit.
1.5.3 Safety Notices
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
CAUTION: SAVE THESE INSTRUCTIONS - This Manual Contains Important Instructions that
should be followed during installation and maintenance of the UPS and batteries.
· Temperature Rating - Units are acceptable for use in a maximum ambient of 40 °C (104°F).
· For PLUGGABLE EQUIPMENT, the socket-outlet shall be installed near the equipment and shall
be easily accessible.
· CAUTION: To reduce the risk of fire, connect model ACDEF3000-11 only to a circuit provided
with 30 amperes maximum branch circuit overcurrent protection in accordance with the National
Electric Code, ANSI/NFPA 70.
· CAUTION: To reduce the risk of fire, connect models ACDEF700-11, ACDEF1000-11,
ACDEF1500-11, and ACDEF2000-11 only to a circuit provided with 20 amperes maximum branch
circuit overcurrent protection in accordance with the National Electric Code, ANSI/NFPA 70.
To Next Page
Loading...
