PowerVision PowerDolphin - Auto Return Functions

You can perform different return functions only when a return point has been
logged successfully. You can check return points from the map in the App. The
image indicates a return point.
PowerDolphin features three auto return functions: smart return, low-battery return, and
return upon disconnection.
1. Return point
Every time you unlock the device, if the GPS signal is good, the current location of the
device will be set as the return point. If the GPS signal is poor, you cannot get the return
point when unlocking the device, and the App will prompt you. In this case, you can
choose to continue to sail or re-unlock your device to update the return point.
2. Smart return
Smart return is a function that can be started two ways:
1） Press and hold the Smart return button on the remote controller;
2） Touch the image in the App and follow the instructions.
You can cancel smart return three different ways:
1） Short press the Smart return button on the remote controller;
2） Move the throttle stick or steering stick again;
3） Touch the image in the App and follow the instructions
When the device starts to return, the remote controller will continue beeping until the
return is canceled or ends.
10
• Auto Return
Please enter Cruise mode in open, obstacle-free waters to prevent PowerDolphin from
hitting obstacles or banks.
2. To exit Cruise mode: Move the throttle stick again to regain speed control.