• Power on: PowerSeeker will power on automatically when its three probes touch the
water at the same time.
• Power off: PowerSeeker will power off automatically one minute after its three probes
move out of water.
• Connection: PowerDolphin and PowerSeeker will connect to each other automatically
when both are powered on and started.
18
• Pairing
PowerSeeker can be used separately, but it cannot be used independently when
connected to PowerDolphin. Therefore, make sure that no mobile device is con-
nected to the Wi-Fi hotspot of PowerSeeker before connecting it to PowerDolphin.
If you replace PowerSeeker or add a new one, you need to pair the new PowerSeeker with
PowerDolphin before use. The pairing steps are as follows:
1. Connect it to PowerDolphin via the remote controller mode or mobile device direct con-
nection mode.
2. Open the Vision+ 2 App, access the product screen of PowerDolphin, and go to
Settings > PowerSeeker settings > PowerSeeker pairing.
To Next Page
Loading...
