PPI HumiTherm-c Series User Manual

10
The Supervisory Parameters provided on PAGE-12 facilitate supervisory control over the operator level. The Table 6.1 below
describes each parameter.
Table 6.1
SUPERVISORY PARAMETERS
BAUD RATE
Communication speed in ‘Bits per Second’. Set the value to match
with the host baud rate.
SP ADJUSTMENT ON PAGE-0
Supervisory permission for Temperature and %RH setpoint
editing on Operator Page (PAGE-0). Set to Enable for permission.
(Default : 1)
1 to 8
(Default : 4800)
ID FOR TEMPERATURE LOOP
Communication ID used by host for temperature value.
(Default : 2)
1 to 8
ID FOR %RH LOOP
Communication ID used by host for %RH value.
(Default : Enable)
Disable
Enable
Parameter Description
Settings
(Default Value)
SELF-TUNE COMMAND
Set to ‘Yes’ to initiate a new tuning cycle or set to ‘No’ to abort a
tuning operation in progress.
Yes
No
(Default : No)
User Manual
HumiTherm-c (Dry-Wet)
Section 6

PPI HumiTherm-c Series Specifications

General

Brand	PPI
Model	HumiTherm-c Series
Category	Controller
Language	English