PPI HumiTherm-c Series - Page 44

42
Figure 10.5
Mounting Output-3 Module
PPI
Plug & Socket
Connector
Projections
Slots
Output
Module
Power Supply Board
Front Label Upright
HumiTherm-c
For plugging out the module(s), follow the steps below:
1. Gently pull apart the Power-supply board and the CPU board until the projections of the module board come out of the
slots.
2. Pull the module outward to unlock the socket from the plug.
Serial Communication Module
The plug for the Serial Communication module is located on the Power-supply board. The Figure 10.6 below illustrates how to
plug-in the Serial Communication module. To plug (or unplug) the module simply insert (or remove) the socket into (or from)
the plug.
Figure 10.6
Mounting Serial Communication Module
User Manual
HumiTherm-c (Temp+RH)
P
P
I
Plug & Socket
Connectors
Serial Communication
Module
Power Supply Board
Front Label
Upside-down
HumiTherm-c