PR electronics 5714 User Manual

24
25
SYMBOL IDENTIFICATION
Triangle with an exclamation mark: Warning / demand. Potentially
lethal situations.
The CE markprovesthecomplianceofthemodulewiththeessential
requirements of the directives.
WARNING!
This module is designed for connection to hazardous electric
voltages.Ignoringthiswarningcanresultinseverepersonal
injury or mechanical damage. To avoid the risk of electric shock
and fire, the safety instructions of this manual must be observed
andtheguidelinesfollowed.Thespecificationsmustnotbe
exceeded, and the module must only be applied as described
inthefollowing.Priortothecommissioningofthemodule,this
manual must be examined carefully. Only qualified personnel
(technicians) should install this module.
If the equipment is used in a manner not specified by the
manufacturer, the protection provided by the equipment may be
impaired.
WARNING!
Until the module is fixed, do not connect hazardous voltages to
the module.
Thefollowingoperationsshouldonlybecarriedoutona
disconnected module and under ESD safe conditions:
Troubleshooting the module.
Repair of the module must be done by PR electronics A/S
only.
GENERAL
HAZARD -
OUS
VOLTAGE
SAFETY INSTRUCTIONS
DEFINITIONS:
Hazardous voltages have been defined as the ranges: 75 to 1500 Volt DC, and
50 to 1000 Volt AC.
Technicians are qualified persons educated or trained to mount, operate, and
alsotroubleshoottechnicallycorrectandinaccordancewithsafetyregulations.
Operators,beingfamiliarwiththecontentsofthismanual,adjustandoperate
the knobs or potentiometers during normal operation.
RECEIPT AND UNPACKING:
Unpackthedevicewithoutdamagingit.Thepackingshouldalwaysfollowthe
device until this has been permanently mounted. Check at the receipt of the
devicewhetherthetypecorrespondstotheoneordered.
ENVIRONMENT:
Avoid direct sunlight, dust, high temperatures, mechanical vibrations and shock,
aswellasrainandheavymoisture.Ifnecessary,heatinginexcessofthestated
limitsforambienttemperaturesshouldbeavoidedbywayofventilation.
All modules fall under Installation Category II, Pollution Degree 1, and Insulation
Class II.
MOUNTING:
Onlytechnicianswhoarefamiliarwiththetechnicalterms,warnings,and
instructionsinthemanualandwhoareabletofollowtheseshouldconnectthe
module.
Should there be any doubt as to the correct handling of the module, please
contact your local distributor or, alternatively,
PR electronics A/S, Lerbakken 10, DK-8410 Rønde, Denmark,
tel: +45 86 37 26 77.
Mountingandconnectionofthemoduleshouldcomplywithnationallegislation
formountingofelectricmaterials,i.a.wirecrosssection,protectivefuse,and
location.DescriptionsofInput/Outputandsupplyconnectionsareshownin
the block diagram and side label.

PR electronics 5714 Specifications

General

Brand	PR electronics
Model	5714
Category	Measuring Instruments
Language	English