PR electronics 5714 - Declaration of Conformity; UL Installation Requirements; Calibration and Adjustment

26
27
Thefollowingapplytofixedhazardousvoltages-connectedmodules:
Themax.sizeoftheprotectivefuseis10Aand,togetherwithapower
switch,itshouldbeeasilyaccessibleandclosetothemodule.The
powerswitchshouldbemarkedwithalabeltellingitwillswitchoffthe
voltage to the module.
UL INSTALLATION REQUIREMENTS:
For use on a flat surface of a type 1 enclosure
Use 60/75°C copper conducters only
Max. ambient temperature ..................... 60°C
Max.wiresize,pins41...46 .................... AWG 30-16
Max.wiresize,others ............................ AWG 30-12
UL file number ........................................ E248256
CALIBRATION AND ADJUSTMENT:
During calibration and adjustment, the measuring and connection of external
voltages must be carried out according to the specifications of this manual. The
technician must use tools and instruments that are safe to use.
NORMAL OPERATION:
Operatorsareonlyallowedtoadjustandoperatemodulesthataresafelyfixed
in panels, etc., thus avoiding the danger of personal injury and damage. This
means there is no electrical shock hazard, and the module is easily accessible.
CLEANING:
Whendisconnected,themodulemaybecleanedwithaclothmoistenedwith
distilledwater.
LIABILITY:
To the extent the instructions in this manual are not strictly observed, the
customercannotadvanceademandagainstPRelectronicsA/Sthatwould
otherwiseexistaccordingtotheconcludedsalesagreement.
DECLARATION OF CONFORMITY
As manufacturer
PR electronics A/S
Lerbakken 10
DK-8410 Rønde
herebydeclaresthatthefollowingproduct:
Type: 5714
Name: Programmable LED indicator
isinconformitywiththefollowingdirectivesandstandards:
The EMC Directive 2004/108/EC and later amendments
EN 61326-1
For specification of the acceptable EMC performance level, refer to the
electrical specifications for the module.
TheLowVoltageDirective2006/95/ECandlateramendments
EN 61010-1
Rønde, 22 December 2009 Kim Rasmussen
Manufacturer’s signature