4/16
PRODUCT INSTALLATION
WARNING：
Please run the safety cord
through safety hole and
make sure that the cord is
property secured.
SAFETY
CORD
CLAMP
CONTROL
PANEL
Take 1 clamp and 1 the safety cord out from the package and mount 1 clamp on the BOTTOM of fixture with 2 retainers
attached to the clamp. Hang the fixture on the steel truss and fasten the retainers attached to the clamp. Always ensure
that the location that you are going to mount the unit is secure and is strong enough to support the weight of the unit (See
the WARNING
as shown above) To pass SAFETY CORD through the SAFETY HOLE on the back cover of the
base of the fixture for safety! Always ensure that the unit is firmly anchored to avoid vibration and slipping whilst
functioning.
WARNING:
1. The unit MUST be lifted or carried by the HANDLES instead of clamps.
2. For safety the safety cord should bear 10 times of the unit’s weight .
To Next Page
Loading...
Need help?
General
