11
6. OPERATION MENU
Menu interface:1. DMX address 2. Config 3. Manual control 4. Scene 5. System settings 6. Information
1) Explanations for menu functions. Push any key to enter into option interface while at initial display
Select “DMX address”option
1）After ENTER key pushed，the current DMX address will
be shown
2）Push UP or DOWN key to set address
3）Push ENTER key to save and exit. Push ESCAPE key to
exit directly
Select ”Channel mode” option
1）After ENTER key pushed, current channel mode will be
shown(20CH for standard mode,16CH for short mode)
2）Push UP or DOWN key to select either of the options；
3）Push ENTER key to save the mode selected. PUSH
ESCAPE key to go back to the upper level menu and
cancel the mode selected
Select “Lamp Striking”Option
1）Push ENTER key to show current mode(Auto lamp-on,
lamp-on by DMX control).
2）Push UP or DOWN key to select either of the options.
3）Push ENTER key to save the mode selected. PUSH
ESCAPE key to go back to the upper level menu and cancel
the mode selected
Select“Pan and Tilt Invert”option
1）Push ENTER key and the options will be shown on the
display（Open or Close）
2）Push UP or DOWN key to select either of the options.
3）Push ENTER key to save the selected. PUSH ESCAPE
key to cancel the setting.
Select“Pan and Tilt Swap”option
1）Push ENTER key and the options will be shown on the
display（Open or Close）
MASTER SLAVE SLAVE
OFF
ON
FUSE 250V 8A
POWER IN POWER OUT
DMX IN DMX OUT
OFF
ON
FUSE 250V 8A
POWER IN POWER OUT
DMX IN DMX OUT
OFF
ON
FUSE 250V 8A
POWER IN POWER OUT
DMX IN DMX OUT
OUTPUT INPUT OUTPUT INPUT
DMX
terminator
To Next Page
Loading...
Need help?
General
