Praktica PLC3 User Manual

Film einlegen
Filmpatrone einlegen. Fangbugel (29) durfen nicht nach oben ste-
hen,
ggf. am gerandelten Spulenteller verstellen. Filmzunge bis zur
grunen Marke (28) ziehen, unter das Haltebockchen (26) schieben.
Zahne der Filmtransportrolle (25) mussen in di e Fi lmperforation ein-
greifen .
Bei
starker Filmkrummung einen Fangbugel durch Drehen am Spu-
lenteller auf den Film auflegen. Ruckspulknopf (2) wieder eindruk-
ken,
ggf. dabei drehen.
Inserting the film
Put
the film cartridge into the cartridge chamber, and observe that
the wire brackets (29) do not point upwards. Adjust at the knurled
spool disk,
if required. Pull the film leader out to the green mark
(28)
and pass it under the support element (26). The teeth of the
film transport sprocket (25) must engage the perforation of the film.
If the film tends to bend heavily, br ing one of the wire brackets on
to the film by rotating the spool disk. Depress the rewind knob (2)
and rotate it, if necessary.
12

Praktica PLC3 Specifications

General

Brand	Praktica
Model	PLC3
Category	Digital Camera
Language	English