PRD 700
9. Never regulate prd 700 on a public road. You will put in danger the
surroundings as well as yourself.
10.While regulating and working on a vehicle inside a garage, make sure garage is
equipped with the appropriate ventilation system.
11.After installation and regulation, make sure you have collected everything
around driver’s seat. Tools and/or wires that are close to the driver may cause
accidents.
Warning!
1. Inappropriate Prd 700 setup may cause engine damage.
2. The regulation must be done only by an expert, who completely understands
turbo s system and the fuel management engine requires.
3. Always make sure everything is right for safe engine overcharging before
increasing it – use the proper proportion of oxygen/fuel while regulating Prd
700.
4. Prd 700 installation requires modification of the vehicle electrical system.
5. While connecting wires, make sure you have removed the key from ignition
and you have disconnected the negative terminal side of the battery.
6. Do not short- circuit the system. It could damage the unit as well as the vehicle
electrical system.
7. Read and understand the wiring diagram before any wire connection.
8. While connecting, push until you hear the click.
Before Installation
Make sure the engine has cooled before working under the hood.
Remove the key and disconnect the negative terminal side of battery.
Before installing the unit valve, make sure the provided pressure tube is long
enough to reach it.
For the Installer
Prd.com.gr - PRD 700 Manual page 4
To Next Page
Loading...