7 Special operating keys ■
43
7 Special operating keys
7.1 The Tare key «0/T»
• Effects taring
– Ensure that the balance is in the weighing mode.
–Briefly press «0/T».
– The balance performs a tare operation.
• Effects a calibration
– Ensure that the balance is in the weighing mode.
– Keep
«0/T» pressed until „CAL“ is displayed.
– Release «0/T».
– The balance carries out a calibration in accordance with the
settings in the configuration menu (see chapter 5.5 “Calibration
functions”) and reports these by means of a printout..
NOTE
A calibration and/or a calibration-test can be cancelled with
«ON/OFF».
To Next Page