INSTALLATION EXPERIENCE
2
MOUNTING LOCATION
WARNING
Your ATOM Series amplifier comes with mounting feet that need to be attached to the
amplifier prior to installation. Once the feet are in place, use the amplifier as a template
and mark the four screw locations. Use caution to make sure there are no objects
behind the installation surface that may become damaged during drilling. The amplifier
should be protected from exposure to moisture and direct sunlight. The best places to
mount your amplifier are: The floor of the trunk, under the driver’s seat, or on the back
of the rear seat. For alternate installation locations.
We recommend you to do a careful planning before you start to install this equipment.
Choose a location for the amplifier which will allow plenty of air to circulate . Do NOT
mount the amplifier upside down under the hat rack. In the amplifier case there are
double mounting holes to make the installation job easier. The screws supplied in the
plastic bag are self drilling when used with an electric screwdriver.
If the surface where you intend to mount the amplifier isn’t big enough you can mount
the amplifier on a separate fiber board or similar. This will also isolate the amplifier
chassis from ground.
NOTE!
Before you start drilling, make sure that there are no fuel or brake lines or wiring
looms behind where you intend to drill.
To Next Page
Loading...
