EasyManua.ls Logo

Precision Power ATOM Series - Functions; Amplifier Controls and Indicators; Connection Terminals and Fuses

Precision Power ATOM Series
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8
FUNCTIONS
6. Remote Bass Boost Control
This control adjusts the Bass Boost gain for the amplifier’s speaker output (0~ +12dB)
Packed product can be different from the photograph.
7. SPEAKER Terminals
As shown in the wiring diagrams, be sure to observe speaker polarity through the system
and speaker impedance. This specially tooled terminal is designed to accommodate p to
10 gauge speaker wire.
8. FUSES
For convenience all ATOM Series amplifiers utilize common automotive ATC type fuses.
For continued protection in the event that a fuse blows, replace the fuse only with the same
value.
9. +BATT (Power Input Connection)
This terminal is the main power input for the amplifier and must be connected directly to
the positive (+) terminal of the car battery.
10. Remote (Remote Input Connection)
All atom Series amplifiers can be turned on by applying 12 volts to this terminal. This can
be found on the rear of the source unit in the form of an electric antenna output, or a
remote output.
If this is not available yo can wire to the ACC position on the key. An 18 gauge wire is
sufficient to run the REMOTE.
11. GND (Ground Input Connection)
A good quality ground is required for your ATOM Series amplifier to operate at peak
performance.
A short length of cable the same gauge as your power cable should be used to attached
the ground terminal directly to the chassis of the vehicle.
12. Power Indicator
The GREEN when the power is on.
(PPI Logo Badge)
13. Gain adjustment control 
The input level can be adjusted with this control. Turn it in the clockwise direction when the
output level of the car audio unit seems low.
14. Sub Sonic Filter
Variable subsonic filter (20Hz ~50Hz)
The subsonic filter will roll off all of the unwanted frequencies below 20HZ ~50Hz.
This will allow the amplifier to use that wasted power on the audible bandwidth.
15. Low pass Filter
ATOM amplifier has an internal variable low pass filter. It can be set from 50 p to 500Hz.
16. Bass boost level control
Turn this control to boost the frequencies around 45Hz to a maximum of 12dB.

Other manuals for Precision Power ATOM Series

Related product manuals