A) No Water Flow when the
cycle activation switch is
pressed.
1. No power to water dispenser.
2. Ensure that there is sufficient purified water
available.
3. Check pump supply.
B) Solenoid Valve does not
turn off at the end of cycle.
1. Debris in solenoid valve is holding the valve
open. Remove the top off from the solenoid valve
by removing screws and check for blockage.
Remove blockage and/or flush valve with clean
water.
Contact any Precision Water Systems Service Centre to correct any
problems with your Water Dispenser that is not covered in this guide.
To locate a Service Centre in your area contact the manufacturer at:
Precision Design & Manufacturing Inc.
9024-100
th
Street
Westlock, Alberta, Canada
T7P 2L4
http://www.precisioncanada.com
e-mail: info@precisioncanada.com
Phone: (780) 349 4933
FAX: (780) 349 4957
Troubleshooting
Caution! Always Disconnect all power and let the water dispenser
cool down completely before completing any Troubleshooting.
To Next Page
Loading...
General